Brushy Creek is the unincorporated community of about 22,500 people wedged between Cedar Park, Round Rock, and Austin, southeast of Leander along FM 1431 and the creek that gives it its name. It was ranch and quarry land until the mid-1970s, when a Williamson County utility district was created in 1977 and later renamed Brushy Creek MUD. The district now covers about 2,300 acres in two pieces, one between Sam Bass Road and FM 1431 and one south of the creek near FM 620, and runs the water, the pools, and the parks for fifteen neighborhoods.
The houses date by neighborhood. Brushy Creek North and South and Cat Hollow are 1980s and 1990s slab homes with copper under the floor and the first attic air handlers. Sendero Springs, Hunter Brook, and the Villages are 2000s two-stories with PEX and attic water heaters. The creek and Brushy Creek Lake sit along the south edge, and the greenbelt lots flood when a storm stalls over the headwaters in Leander and Cedar Park.
Your call reaches an independent local water damage provider serving Brushy Creek by phone. The provider reads the house with a meter before deciding what opens.
A warm tile and a high bill in a Brushy Creek North house is a leak detection call, and the copper under those slabs is the usual reason. An attic tank that let go above a Sendero Springs hallway is water heater leak cleanup. A greenbelt lot that took creek water is flash flood cleanup rather than a simple dry-out.
Brushy Creek MUD treats water from Lake Georgetown and its own wells and is the one to call if the leak is on the street side of the meter; the district also reviews building permits alongside Williamson County, since there is no city here to issue them.
Call (737) 317-2602 and describe what you found. We route the call to an independent local water damage provider serving Brushy Creek.
Standing water pulled off the slab, the upstairs subfloor, and the garage in a Leander two-story, with meter readings taken before anything is cut.
Dehumidifiers and air movers sized for a humid Hill Country summer, run until the drywall, the stair treads, and the cabinets read dry.
A high Leander water bill, a warm tile, or a soft wall traced to a PEX fitting, a slab line, or a manifold before anyone opens the floor.
Ceilings, walls, and floors soaked when an attic or exterior wall line split in a freeze, pumped out and dried once the valve is closed.
Creek water and street runoff pulled out of a garage or ground floor, contaminated materials removed, and the house dried afterward.
An attic or garage tank that let go, and the ceiling, insulation, closet, and flooring it soaked on the way down, dried and opened only where wet.
A stain or sag under an upstairs bath, an attic air handler, or a drain pan, metered from above before the drywall comes down.
Wet insulation, ceilings, and walls dried out after Hill Country hail or a stalled spring storm found a gap in the shingles or flashing.